This holds true even if all of the items with stems going in one direction have been removed. When removing notes from an existing chord that includes dual stem directions, the remaining items will still have their stem direction set. Chord members can be removed from a chord in a similar fashion by pressing when the insertion point is directly to the right of the note to be removed. This automatically executes the chord member command. The reverse is also true: a note with its stem going upward cannot be combined with a higher note that has a downward stem.Ĭhord members can be added most efficiently by pressing from the computer keyboard. A note with its stem going downward cannot be combined with a lower note which has its stem going upward.The stem direction assigned to the rest must be different (opposite) than the note that is being added, or the operation will fail. The duration of the rest must be smaller than that of the notes that are added to it. A chord containing a rest is created by first placing the rest, and then adding one or more notes to that rest.Attempts to add a third duration type to an existing chord, or two notes of differing duration but the same stem direction, will be rejected. If a chord member is added to an existing note, it must have the same duration, or it must be in the opposing stem direction.If only one of two overlapping notes is to be dotted, then ties should be used to demonstrate which voice is extended. If either of these notes are dotted, then both should be dotted, or the visual results may be confusing to the reader. Two notes at the same vertical position but with differing accidentals should never be added to the same chord or unpredictable results will occur.no other notes below them in the chord have a stem up.no other notes above them in the chord have a stem down.Two notes with the same pitch but differing duration or stem direction cannot be added to the staff unless: In most cases, a chord can contain only one note at each vertical position on the staff. The following rules apply to chords in NoteWorthy Composer 2: When combining notes with a previously placed rest, the stem direction tools can be used to control whether the notes appear above or below the rest. If the new note's stem direction and note position is consistent with the note, rest, or chord to the left of the insertion point, then the new note is combined with the item to the left. If the operation is not allowed (due to a rules violation, as described below), the computer will beep and no change will occur.Ī chord is capable of supporting notes of two differing duration and/or differing stem directions. If only a single note or rest is present prior to executing this command, a new chord will be formed that combines this new note with the prior item. This command adds a new note to an existing note, rest, or chord that is just behind the insertion point.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |